PRINCIPAL TECHNICAL MANAGER FOR ELECTROMAGNETIC & SENSOR SYSTEMS

Summary You will serve as the PRINCIPAL TECHNICAL MANAGER FOR ELECTROMAGNETIC & SENSOR SYSTEMS at Naval Surface Warfare Center Dahlgren Division (NSWCDD). Responsibilities You will serve as the Head, Electromagnetic and Sensor Systems Department, and is a 3rd level supervisor responsible for leading and supervising in excess of 800 government scientists, engineers, technicians, and support personnel. You will provide expert advice, recommendations, and counsel to a large and broad array of customers, sponsors, and partners. You will interface frequently with The Missile Defense Agency (MDA) and at the Flag/SES level with Office of Naval Research (ONR). You will participate in Technical Reviews, Failure Review Boards, and conduct Deployment Readiness Reviews of systems for which the Electromagnetic and Sensor Systems Department performs research and development. You will interface frequently with Program Executive Office integrated Warfare Systems (PEOIWS), The Missile Defense Agency (MDA) and at the Flag/SES level with Office of Naval Research (ONR). You will serve in special capacities at the direction of the NSWCDD Technical Director and NSWC Executive Director such as technical reviews, failure review boards, concept development, and laboratory tests. Requirements Conditions of Employment Qualifications The applicant is to provide a separate narrative statement which describes fully, but concisely, how his/her experience supports each of the following Mandatory Technical Qualifications. Each technical qualification narrative should not exceed 2 pages. Failure to address these specific qualifications in a separate narrative statement will eliminate you from consideration: 1. Knowledge of Naval Surface Radar Systems, Naval Surface Electronic Warfare, Combat System Safety, Spectrum Management, Electromagnetic Effects and Integrated Topside Design and the associated underlying science and engineering disciplines required to ensure successful system development. 2. Knowledge of research and engineering best practice techniques for systems engineering, software engineering, test and evaluation, and modeling and simulation with application to core Naval Surface Radars, Naval Surface Electronic Warfare, Spectrum Management, and Electromagnetic Effects technical competencies. 3. Ability to provide stewardship of technical capabilities and interface with the Technical Warrant Holder community relative to electromagnetics, radars and sensors. 4. Knowledge of techniques and practices in leading the future direction of research and development in technical capability domains to solve complex S&T challenges with innovative approaches. Additional qualification information can be found from the following Office of Personnel Management website: https://www.opm.gov/policy-data-oversight/classification-qualifications/general-schedule-qualification-standards/#url=GS-PROF AND 1301 General Physical Science Series 1515 Operations Research Series 1520 Mathematics Series 1550 Computer Science Series Experience refers to paid and unpaid experience, including volunteer work done through National Service programs (e.g., professional, philanthropic, religious, spiritual, community, student, social). Volunteer work helps build critical competencies, knowledge, and skills and can provide valuable training and experience that translates directly to paid employment. Education Applicants must meet the following positive education qualifications requirements of the Office of Personnel Management (OPM) Qualifications Standards Manual: For 0801 Professional Engineering Series: A. Degree: Engineering. Successful completion of a bachelors or higher engineering degree from an accredited college or university. To be acceptable, the program must: (1) lead to a bachelors degree in a school of engineering with at least one program accredited by ABET; or (2) include differential and integral calculus and courses (more advanced than first-year physics and chemistry) in five of the following seven areas of engineering science or physics: (a) statics, dynamics; (b) strength of materials (stress-strain relationships); (c) fluid mechanics, hydraulics; (d) thermodynamics; (e) electrical fields and circuits; (f) nature and properties of materials (relating particle and aggregate structure to properties); and (g) any other comparable area of fundamental engineering science or physics, such as optics, heat transfer, soil mechanics, or electronics. Such education must demonstrate the knowledge, skills, and abilities necessary to do the work of the position. -or- B. Combination of education and experience — college-level education, training, and/or technical experience that furnished (1) a thorough knowledge of the physical and mathematical sciences underlying engineering, and (2) a good understanding, both theoretical and practical, of the engineering sciences and techniques and their applications to one of the branches of engineering. The adequacy of such background must be demonstrated by one of the following: (I) Professional registration or licensure — Current registration as an Engineer Intern (EI), Engineer in Training (EIT), or licensure as a Professional Engineer (PE) by any State, the District of Columbia, Guam, or Puerto Rico. Absent other means of qualifying under this standard, those applicants who achieved such registration by means other than written test (e.g., State grandfather or eminence provisions) are eligible only for positions that are within or closely related to the specialty field of their registration. For example, an applicant who attains registration through a State Boards eminence provision as a manufacturing engineer typically would be rated eligible only for manufacturing engineering positions; or (II) Written Test — Evidence of having successfully passed the Fundamentals of Engineering (FE) examination or any other written test required for professional registration by an engineering licensure board in the various States, the District of Columbia, Guam, and Puerto Rico; or (III) Specified academic courses — Successful completion of at least 60 semester hours of courses in the physical, mathematical, and engineering sciences and that included the courses specified in the basic requirements under paragraph A. The courses must be fully acceptable toward meeting the requirements of an engineering program as described in paragraph A; or (IV) Related curriculum — Successful completion of a curriculum leading to a bachelors degree in an appropriate scientific field, e.g., engineering technology, physics, chemistry, architecture, computer science, mathematics, hydrology, or geology, may be accepted in lieu of a bachelors degree in engineering, provided the applicant has had at least 1 year of professional engineering experience acquired under professional engineering supervision and guidance. Ordinarily there should be either an established plan of intensive training to develop professional engineering competence, or several years of prior professional engineering-type experience, e.g., in interdisciplinary positions. (The above examples of related curricula are not all inclusive.) For 1301 General Physical Sciences Series: Successful completion of a degree in physical science, engineering, or mathematics that includes 24 semester hours in physical science and/or related engineering science such as mechanics, dynamics, properties of materials, and electronics; or, a combination of education and experience in one of the above majors that includes at least 24 semester hours in physical science and/or related engineering science, plus appropriate experience or additional education. For 1515 Operations Research Series: Successful completion of a degree in operations research. or A degree with at least 24 semester hours in a combination of operations research, mathematics, probability, statistics, mathematical logic, science, or subject-matter courses requiring substantial competence in college-level mathematics or statistics. At least 3 of the 24 semester hours must have been in calculus. For 1520 Mathematics Series: A. Degree: mathematics; or the equivalent of a major that included at least 24 semester hours in mathematics.-or-B. Combination of education and experience — courses equivalent to a major in mathematics (including at least 24 semester hours in mathematics), as shown in A above, plus appropriate experience or additional education. For 1550 Computer Science Series: Bachelors degree in computer science or bachelors degree with 30 semester hours in a combination of mathematics, statistics, and computer science. At least 15 of the 30 semester hours must have included any combination of statistics and mathematics that included differential and integral calculus. All academic degrees and course work must be from accredited or pre-accredited institutions. An advanced degree of Masters or Ph.D. in one of the educational fields listed above is highly desirable. Additional Information Senior Scientific Technical Manager (SSTM) positions are positions which exceed the ND-05 (GS-15 equivalent). SSTMs provide a continuity of technical leadership and oversight that is needed to ensure long term stewardship of an organizations technical capabilities. Typically, applicants for SSTM positions are expected to have a graduate degree, significant research or development experience, and a national or international reputation in his/her field and are recognized throughout the applicable community as a renowned expert. SSTM positions are in the competitive service. This position is not covered by the Department of Defense Priority Placement Program. Additional vacancies may be filled by this announcement. A tentative offer of employment will be rescinded if the selectee fails to meet the pre-employment requirements, including failure to report to any of the scheduled appointments. Federal annuitant information: The selection of an annuitant is subject to the Department of Defense and Department of the Navy policy on the employment of annuitants. Policy information may be found at: http://www.secnav.navy.mil/donhr/Documents/CivilianJobs/FedCivAnnuitants.pdf Certain incentives (such as Recruitment, Relocation or Student Loan Repayment) may be authorized to eligible selectees. A relocation incentive is generally a single payment intended to offset some of the relocation costs experienced by the selectee. A relocation incentive may be authorized.